Skoda Octavia Workshop Manual page 21

OCTAVIA
Edition 04.01
S00.5104.54.20
Removing and Installing Engine
Procedure
Installation is carried out in the reverse order;
pay attention to the following points:
- Check whether dowel sleeves for centering
engine/gearbox are present in the cylinder
block, insert if necessary.
K - Attach intermediate plate to sealing flange
and push onto the dowel sleeves -arrows-.
Models with manual gearbox
- Inspect centering of clutch driven plate.
- Inspect clutch release bearing for wear, re-
place if necessary.
- Apply a thin film of grease G 000 100 to
splines of input shaft.
- Install slave cylinder of hydraulic clutch:
⇒ 5-Speed Manual Gearbox 02J, Repair
Group 30.
Models fitted with automatic gearbox
- Use only nuts which are approved in the list
of parts for attaching the torque converter to
the driven plate.
Continued for all models
- Align engine/gearbox mounting ⇒ page 10-
15.
- Attach shift cables to gearbox and adjust:
⇒ 5-Speed Manual Gearbox 02J, Repair
Group 34.
⇒ Automatic Gearbox; Repair Group 37.
Models fitted with AC
- Install AC compressor:
⇒ Heating and Air Conditioning, Repair Group
87.
Continued for all models
- Install power steering hydraulic pump
⇒ Running Gear; Repair Group 48.
- Install catalytic converter and align exhaust
system free of stress ⇒ page 26-1.
- Fit on coolant hoses ⇒ page 19-1.
10
------------ 10-13 ------------