Skoda Octavia Workshop Manual page 50

13
------------ 13-22 ------------
Crank Assembly
K Fig. 2 Inspecting pistons
Special tools, testers and aids required
♦ External micrometer 75 to 100 mm
Inspection procedure
- Measure about 10 mm from bottom edge, at
right angles to piston pin axis.
♦ Variations compared to nominal size
max. 0.04 mm
K Fig. 3 Bearings installation position
Bearing shell -1- with oil drilling -arrow- for con-
necting rod.
Bearing shell -2- with oil drilling for connecting
rod.
- Position bearing shell in the middle of the
connecting rod and conrod bearing cap
The dimension -a- must be the same on right
and left, max. variation 0.2 mm.
K Fig. 4 Inspecting cylinder bore
Special tools, testers and aids required
♦ Internal precision measuring instrument 50
to 100 mm
Inspection procedure
- Measure at 3 points diagonally across in
transverse direction -A- and in longitudinal
direction -B-
♦ Variations compared to nominal dimen-
sion
max. 0.10 mm
Note:
The measurement of the cylinder bore must not
be performed when the cylinder block is at-
tached with Engine holder MP 1-202 to the re-
pair stand otherwise incorrect measurements
may result.
OCTAVIA
Edition 04.03
S00.5104.56.20