Skoda Octavia Workshop Manual page 93

OCTAVIA
10 - Gasket with baffle plate
♦ Replace
♦ Pay attention to installation position
11 - Oil spray nozzle
♦ For cooling pistons
12 - Pressure relief valve, 27 Nm
♦ Opens at:
0.25 ... 0.32 MPa
♦ Insert without sealant
13 - Baffle plate
♦ Install only if oil pump in place
14 - Oil pump with chain sprocket
♦ For removing and installing, take out
oil pan ⇒ page 17-6
♦ Disassembling and assembling
⇒ page 17-5
♦ Testing oil pressure and oil pressure
switch ⇒ page 17-8
15 - 15 Nm
♦ Slacken and tighten with hinged
wrench and wrench bit
16 - Oil pan
♦ Removing and installing
⇒ page 17-6
17 - 15 Nm
18 - Spacer sleeve
♦ Pay attention to installation position
19 - Seal
♦ Replace
20 - Oil drain plug, 40 Nm
Edition 08.98
S00.5104.52.20
Lubrication System
21 - Dowel sleeve
♦ For centering oil pump/cylinder block
22 - Chain for oil pump
♦ Mark direction of running before re-
moving
♦ Inspect for wear
23 - Front sealing flange
♦ Should be located on dowel sleeves
♦ Removing and installing
⇒ page 13-15
24 - Seal
♦ Replace ⇒ page 13-11
25 - Central bolt
♦ Replace
♦ 90 Nm + torque a further 90 (¼ turn)
♦ Use counterholder MP 1-310 for
slackening and tightening
♦ When attaching counterholder, place
2 washers between toothed belt
sprocket and counterholder
26 - Crankshaft toothed belt sprocket
♦ Can be installed only in one position
27 - Chain sprocket
♦ For oil pump drive
28 - Chain tensioner with tensioning rail,
25 Nm
♦ Pay attention to installation position
♦ If spring broken, replace complete
chain tensioner
17
------------ 17-3 ------------