Skoda Octavia Workshop Manual page 45

OCTAVIA
Edition 04.03
S00.5104.56.20
Crank Assembly
K - Apply silicone sealant bead to the clean seal-
ing surface of the sealing flange as shown in
the illustration.
- Fit on sealing flange immediately and tighten
all the bolts slightly.
Notes:
♦ If a PTFE seal is fitted ⇒ page 13-11, Fig. 2,
the crankshaft journal must be free of oil and
grease and the seal must not be oiled.
K ♦ Use the following devices for fitting on the
sealing flange with the seal installed:
- Elastomer seal - MP 1-314
- PTFE seal - T10053/1
- Tighten bolts of sealing flange across to 15
Nm.
- Install oil pan ⇒ page 17-6.
Note:
After installing, allow the sealant to dry for about
30 minutes. Do not pour in any engine oil during
this waiting period.
- Install toothed belt ⇒ page 13-5.
- Installing ribbed V-belt and tensioning device
⇒ page 13-1, removing and installing ribbed
V-belt.
13
------------ 13-17 ------------