Skoda Octavia Workshop Manual page 18

10
------------ 10-10 ------------
Removing and Installing Engine
Models with air conditioning
Warning!
The refrigerant circuit of the air conditioning sys-
tem must not be opened.
K - Unbolt compressor of air conditioning sys-
tem, lower together with the connected re-
frigerant hoses and tie up with a wire at the
towing eye on the inside of the bumper -ar-
row-.
Note:
Protect bumper from scratches with adhesive
tape.
All models
- Remove drive shaft cover.
- Remove catalytic converter ⇒ page 26-1.
K - Unbolt pendulum support -arrows-.
- Unbolt drive shafts from flange shaft of gear-
box.
- Place left drive shaft to the rear and secure
with wire.
- Remove right drive shaft:
⇒ Running Gear; Repair Group 40; Servicing
drive shaft
- Insert engine holder T10012 into engine/
gearbox lift (e.g. V.A.G 1383 A).
K - Attach engine holder T10012 to the cylinder
block using the securing nut and M10 bolt,
tightened to a torque of about 40 Nm.
- Raise engine and gearbox slightly with en-
gine/gearbox lift (e.g. V.A.G 1383 A).
OCTAVIA
Edition 08.98
S00.5104.52.20