Skoda Octavia Workshop Manual page 99

OCTAVIA
Edition 08.98
S00.5104.52.20
¤ ¥ ¦ § ¨ ©   ¨    ¥ ¦ ¦   ¥
Lubrication System
K - Unplug connector of 0.14 MPa oil pressure
switch (black insulation) and remove oil pres-
sure switch -arrow-.
- Screw oil pressure switch into the oil pres-
sure tester.
¤ ¥ ¦ § ¨ ©   ¨    ¥ ¦ ¦   ¥ ¦ - Screw oil pressure tester into the oil filter
holder in place of the oil pressure switch.
- Start engine (engine oil temperature at least
80 °C).
♦ Oil pressure at idling speed: 0.2 MPa
♦ Oil pressure at 3000 rpm: 0.30...0.45 MPa
If the specified pressures are not achieved:
- Replace pressure relief valve in oil filter
holder ⇒ page 17-4 or oil pump
⇒ page 17-5, respectively.
- Unplug connector of 0.14 MPa oil pressure
switch (black insulation) and remove oil pres-
sure switch -arrow-.
K - Screw oil pressure switch into the oil pres-
sure tester.
- Screw oil pressure tester into the oil filter
holder in place of the oil pressure switch.
- Connect brown cable of tester to earth (-).
- Connect diode test lamp to oil pressure
switch and to battery positive (+) using aux-
iliary cables.
- Start engine and slowly increase engine
speed.
♦ The LED should light up at a pressure of
0.12...0.16 MPa; if not, replace oil pres-
sure switch.
 ¨ §  
------------
17
¡ ¢ £
------------