Skoda Octavia Workshop Manual page 83

OCTAVIA
Edition 08.96
S00.5104.50.20
Cylinder Head, Valve Gear
♦ Valve depressor MP 1-229
♦ Thrust piece MP 1-229/1
♦ Puller MP 1-230
♦ Fitting tool MP 1-233
♦ Spark plug wrench
Removing
- Remove camshafts ⇒ page 15-16.
- Remove bucket tappets (do not mix up) and
place down with the running surface facing
down.
- Use spark plug wrench to remove spark
plugs.
- Position piston of the relevant cylinder to
„bottom dead centre".
Exhaust side
K - Insert assembly device MP 1-213 and set
bearing to height of stud bolt.
Note:
The rear stud bolts on the exhaust side should
be unscrewed in order to install the assembly
device MP 1-213 on the exhaust side.
- Screw pressure hose MP 1-210 into the
spark plug thread and apply a constant
pressure at least 0.6 MPa
- Use assembly lever and thrust piece MP
1-211 to remove valve springs.
Note:
If valve collets are tight, detach with light blows
from a hammer on the assembly lever.
K - Use puller MP 1-230 to pull off valve stem
seals.
15
¡ ¢ £ ¤
------------ ------------