Skoda Octavia Workshop Manual page 72

15
¡ ¢ £ ¤
------------ ------------
Cylinder Head, Valve Gear
K - Install camshaft sprocket.
♦ Pay attention to installation position:
The narrow web of the camshaft sprocket
points out -arrows- and the TDC marking
of cyl. 1 is visible.
- Install the bolt for attaching camshaft
sprocket and tighten to
65 Nm
(use counterholder MP 1-216).
- Insert orifice plate for Hall sender with the
notch engaging in the inlet camshaft.
- Install washer (with taper facing out) and
tighten the securing bolt to
25 Nm.
- Install housing for Hall sender and tighten to
10 Nm.
- Install cylinder head cover ⇒ page 15-2.
K - Align marking on camshaft sprocket with
marking on cylinder head cover.
Note:
When the camshaft is rotated, the valves may
strike the pistons if they are positioned at TDC.
For this reason, the pistons must not be posi-
tioned at TDC. Risk of damage to valves and
pistons.
- Align marking on vibration damper with mark-
ing on bottom part of toothed belt guard.
K - Inspect whether TDC marking on flywheel
and reference mark are aligned -arrows-.
- Fit toothed belt onto the camshaft sprocket.
OCTAVIA
Edition 08.98
S00.5104.52.20