Skoda Octavia Workshop Manual page 34

13
------------ 13-8 ------------
Crank Assembly
K - Check whether TDC marking on flywheel and
reference mark on driven plate are aligned
-arrow-.
I - Manual gearbox
II - Automatic gearbox
- Remove vibration damper.
- Remove bottom part of toothed belt guard.
- Mark direction of running of toothed belt.
K - Screw tensioning bolt T 10092 into the
toothed belt tensioning device.
- Tension pressure plunger of tensioning de-
vice only sufficiently to allow the pressure
plunger to be secured with a locking pin (e.g.
T 40011).
- Take off toothed belt.
Installing, tensioning toothed belt
Note:
When the camshaft is rotated, the valves may
strike the pistons if they are positioned at TDC.
For this reason, the pistons must not be posi-
tioned at TDC. Risk of damage to valves and
pistons.
K - Align marking on camshaft sprocket with the
marking on the cylinder head cover.
- Fit toothed belt onto toothed belt sprocket of
crankshaft (pay attention to direction of run-
ning).
- Install bottom part of toothed belt guard.
Tightening torque: 10 Nm
- Install vibration damper for crankshaft (pay
attention to installation position, holes offset).
Tightening torque: 25 Nm
OCTAVIA
Edition 02.02
S00.5104.55.20