Skoda Octavia Workshop Manual page 134

26
¡ ¢ £
------------ ------------
¤ ¥ ¦ § ¨ © ©  ¥ 
Exhaust System
Installation is carried out in the reverse order;
%       " & ' ( )  ¨ ©         ! " #  $
pay attention to the following points:
0 0 © ¦ 1
§
- Fit exhaust manifold onto the cylinder head
with new gasket.
- Fit on washers and tighten the securing nuts
evenly diagonally across.
Tightening torque: 25 Nm
- Attach shield tight to exhaust manifold.
Tightening torque: 25 Nm
- Install front exhaust pipe ⇒ page 26-2.
♦ Torque wrench 5...50 Nm
(e.g. V.A.G 1331)
♦ Body saw (e.g. V.A.G 1523)
A separation point is provided for repair opera-
tions in order to replace the centre silencer or
the rear silencer.
K - Use body saw (e.g. V.A.G 1523) to separate
exhaust pipe at right angles at the separa-
tion point -arrow 2-.
- Position clamping sleeve -4- at the side
markings -arrows 1 and 3- when installing.
- Align exhaust system free of stress ⇒ page
26-5.
- Align rear silencer horizontally.
- Tighten the bolted connections of the clamp-
ing sleeve evenly to 40 Nm.
- Installation position of clamping sleeve: hori-
zontal in vehicle, bolted connections facing
forward.
# " "   "
3 4  2 ( 5
§ ( ¦ § (
2 ¦ 2 (
and aids
OCTAVIA
Edition 08.98
S00.5104.52.20