Avaya IP500 V2 Installation Manual page 213
Hide thumbs
Also See for IP500 V2:
- Installation manual (144 pages) ,
- Installation manual (426 pages) ,
- Installation manual (71 pages)
Table of Contents
Advertisement
Ports
Description
AUDIO
3.5mm Stereo jack socket. Used for external music on hold source input.
390
AUX
· If pressed during a restart of the control unit, the control unit
124
folder on the System SD card.
· If pressed for more than 5 seconds when a system is running, the control unit shuts down for 10
minutes.
CPU
Indicates the status of the control unit.
· Alternate red/green = Starting up.
· Green on = Okay.
EXPANSION
RJ45 socket. Used for direct connection to external expansion modules using the Expansion Interconnect
395
cable supplied with the expansion module.
EXT O/P
3.5mm Stereo jack socket. Used for switching external relay systems such as door entry controls. The
173
port contains two independent switches controlled by the IP Office.
INPUT
AC power input port.
40
LAN
RJ45 socket. The port is a full-duplex 10/100Mbps auto-sensing, MDI crossover port. With the WAN port
396
forms a managed layer 3 Ethernet switch.
Optional SD
Used for the Optional SD card. The LED is used in the same way as for the System SD (see below).
122
RESET
This switch is used to restart the IP Office, optionally erasing the configuration and or the core software in
181
the process. See
RS232
9-Way D-Type socket. Used for system maintenance.
System SD
Used for the System SD card,. The LED is used as follows.
122
· Off = Card shutdown.
· Green on = Card present.
· Green flashing = Card in use.
· Orange steady = Reset imminent.
WAN
RJ45 socket. The port is a full-duplex 10/100Mbps auto-sensing, MDI crossover port. With the WAN port
396
forms a managed layer 3 Ethernet switch. This port is not supported on systems running in IP Office Basic
Edition - PARTNER® Mode, IP Office Basic Edition - Norstar Mode or IP Office Basic Editions.
Used for connection of a
recommended and for some locales may be a regulatory requirement.
Installing IP500/IP500 V2
IP Office 9.0
Reset Button
.
181
functional or protective ground
System Components: IP500 V2 Control Unit
skips booting
124
· Red on = No software.
· Flashing Red = Error/Shutdown.
· Red flashing = Card initializing or shutting
down.
· Red fast flashing = card full
· Red steady = Card failure/wrong type.
. Use of a ground for all systems is
92
15-601042 Issue 28c (19 August 2013)
from the /primary
Page 213
Advertisement
Table of Contents
