Atm Combination Card - Avaya IP500 V2 Installation Manual

Hide thumbs Also See for IP500 V2:
Table of Contents

Advertisement

10.3.3 ATM Combination Card

These cards are used to add a combination of ports to an IP500 V2 control unit. Not supported by IP500 control units. The
newer IP500 ATM Combination Card V2 version is supported by IP Office Release 8.1 Feature Pack 1 and higher only.
Port Type
Ports
Digit Station
1 to 6
Analog
7 to 8
Extension
Analog Trunk
9 to 12
Installing IP500/IP500 V2
IP Office 9.0
· Supports
· 10 voice compression channels. Codec support is G.711, G729a
· 6 Digital Station ports for
· 2 Analog Extension ports.
· 4 Analog Trunk ports:
· IP500 Control Unit:
· IP500 V2 Control Unit:
· Maximum per Control Unit: 2 combination cards of any type per
IP500 V2 control unit.
· IP500 Trunk Card Support:
installed and cannot be replaced with another card type.
· IP Office Software Level: 6.0+.
This depends on the version of the card as follow:
· V1: 6.0+. New build PCS04 cards are only supported in systems
· V2: IP Office Release 8.1 Feature Pack 1 or higher.
Features
Provides
DS
ports for
393
LEDs
· Green Flashing = Phone detected.
· Green On = Phone active.
· LED1 is also used for base card status:
· Red On = Error
· Red Slow Flash = Initializing.
· Supports ICLID modes DTMFA, DTMFC, DTMFD, FSK and UK20.
· REN 2 (1 for external bell device).
· Off-Hook current: 25mA
· Ring Voltage: 40V.
· Intended for connection to two-wire analog phones, the ports do not include a ringing
capacitor. For connection to 4-wire analog phones, connection should be via a master
socket with ringing capacitors.
· During power failure extension port 8 is connected to the analog trunk port 12.
· No status LEDs are used for analog phone extensions.
· DTMF, ICLID and busy tone detection.
· Over-voltage/lightning protection (may still require
· DTMF and LD (loop disconnect) dialing.
· Echo cancellation.
LEDs
· Green on = V1: Card installed. V2: Line connected to the port but idle.
· Green flashing = Line in use.
· LED 9 is also used for daughter card status.
· Red On = Error
· Red Slow Flash = Initializing.
and G.723 with 64ms echo cancellation. G.722 is supported by IP
Office Release 8.0 and higher.
4400, 7400, M and T-Series).
Depending on the version of combination card, V1 or V2, the
analog trunk daughter card is equivalent to an
Trunk Card 4
V1 or V2 respectively.
235
running IP Office Release 6.1(20), 7.0(12) or 8.0 and higher.
Refer to IP Office Technical Tip 237.
digital stations
(except 4100, 4400, 7400, M and T-Series).
48
· Red Flash every 5 seconds = Card okay.
· Red Fast Flash = System shutdown.
· Red Flash every 5 seconds = Card okay.
· Red Fast Flash = System shutdown.
digital stations
(except 3800, 4100,
48
IP500 Analog
1. The trunk daughter card is pre-
additional protection equipment
15-601042 Issue 28c (19 August 2013)
).
45
Page 222

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ip500

Table of Contents