Connecting Phones; Analog Phones; Etr Phones; Ds Phones - Avaya IP500 V2 Installation Manual
Hide thumbs
Also See for IP500 V2:
- Installation manual (144 pages) ,
- Installation manual (426 pages) ,
- Installation manual (71 pages)
Table of Contents
Advertisement
4.13 Connecting Phones
During initial power up, the IP Office automatically creates extension and user entries for all analog and digital extension
ports (DS and TCM) in the system. This allows those devices to be connected without any additional programming.
!
Warning
·
If the system has been upgraded from a previous release of IP Office software, all phones will be restricted from
making any calls until a
to make emergency calls.
· This section does not cover the installation of DECT, H323 and SIP telephones. For installation of those devices
refer to the appropriate supplementary installation manuals.
4.13.1 Analog Phones
Connect any analog phones to their appropriate
are clearly labeled as such.
4.13.2 ETR Phones
Connect any ETR phones to their appropriate
4.13.3 DS Phones
Connect any digital phones to their appropriate
that supported by the IP Office core software. The appropriate firmware is supplied with the IP Office Manager software
and copied onto the System SD card for IP500 V2 systems.
The phones will automatically load the firmware from the IP Office system if necessary.
· The upgrade process takes approximately 10 minutes during which time the phone will display a warning. The
phone should not be disconnected during this process.
· Due to memory requirement, only 10 phones of the same type can be upgraded at a time. Starting from the first
port needing to be upgraded, the IP Office will upgrade all connected phones of the same type needing upgrading in
batches. It will then upgrade the next connected type of phones needing to be upgraded.
· Once the phone connected to a port has been upgraded, the IP Office will not check whether the phone on that port
needs to be upgraded again except following a system reboot, i.e. multiple phones cannot be upgraded by
swapping the connected phones on the same.
Installing IP500/IP500 V2
IP Office 9.0
system upgrade license
403
Phone
398
ETR
ports. These phones do not need to load additional firmware.
394
DS
ports. These phones may need to upgrade their firmware to match
393
IP500 V2 Installation: Changing the System to Standard Mode
has been entered. The dialing restriction includes not being able
ports. Ensure that those connected to
power failure ports
15-601042 Issue 28c (19 August 2013)
57
Page 99
Advertisement
Table of Contents
