9.13.2 Wall Mounting Kit V1
Installing IP500/IP500 V2
IP Office 9.0
These notes relate to the older design of wall mounting kit (SAP 70043015) used
for IP500 and IP500 V2 control units. This kit cannot be used for external
expansion modules.
The kit includes two brackets, one top and one bottom, and screws for attachment
to the control unit. Additional 4 x 4.5mm fixtures and fittings are required suitable
for the wall type.
In addition to the existing
the following additional requirements apply when wall mounting a unit:
· The wall surface must be vertical, flat and vibration free. Attachment to
temporary walls is not supported.
· Only the screws provided with the mounting kit should used to attach the
brackets to the control unit.
· The brackets must be used as shown, with the deeper tray-like bracket used
at the bottom of the wall mounted control unit.
IP500 Basic Installation: Wall Mounting
environmental requirements
15-601042 Issue 28c (19 August 2013)
for an IP Office system,
60
Page 207