Fitting Ip500 Legacy Cards - Avaya IP500 V2 Installation Manual

4.5.2 Fitting IP500 Legacy Cards

An IP500 Legacy Carrier card can be used to fit IP400 trunk or VCM cards into an IP500 or IP500 V2 control unit. Up to 2
IP500 legacy carrier cards can be inserted.
Installing IP500/IP500 V2
IP Office 9.0
PRI T1 PRI 30 E1R2 RJ45
Dual PRI T1 Dual PRI E1R2 RJ45
PRI 30 E1 (1.4) BRI-8 (UNI)
Dual PRI E1 ANLG 4 Uni (US only)
Warnings
1. Correct anti-static protection steps should be taken while handling
Parts and Equipment Required
1. o IP500 Carrier Card
2. o IP400 Card
Tools Required
1. o 5mm Flat-blade screwdriver.
2. o Anti-static wrist strap and ground point.
Procedure: Installing a Carrier Card
1. Check that correct cards have been supplied.
2. Ensure that you are wearing an anti-static wrist strap connected to
3. On the carrier card identify the position of the jumper block and
4. If fitting an IP400 trunk card, identify which of the plastic snap-off
5. Fit the stand off pillars to the IP500 carrier card.
6. Using minimal force and checking that the pins are correctly
IP500 V2 Installation: IP500 Card Installation
circuit boards.
The table opposite lists supported cards. Any card not listed is not
supported. Cards are supplied with 2 plastic stand off pillars. Trunk
cards are also supplied with a replacement blanking plate which is
not required.
a suitable ground point.
stand off pillar holes for the IP400 card. The peg holes are labeled
as VCM or TRUNK.
panels on the front of the carrier card need to be removed to allow
the trunk cable connections. Carefully remove those panels.
located, push the IP400 card onto its jumper and the stand off
pillars.
VCM 4
VCM 8
VCM 16
VCM 24
VCM 30
15-601042 Issue 28c (19 August 2013)
Page 85