Entering Licenses - Avaya IP500 V2 Installation Manual

5.1 Entering Licenses

For IP500 V2 control units,
merged with the configuration when the control unit is powered up. Otherwise for all control units, licenses are entered
into the configuration using IP Office Manager. In addition to the methods below, license can also be added by placing the
addition licenses as a text file on the System SD card
You must ensure that the licenses being entered have been issue against the FK serial number of the System SD card
fitted in the system. Each license is a unique 32-character string based on the feature being licensed and the serial
number of the SD card plugged into the system control unit.
Entering licenses manually is liable to errors caused by miskeying the correct 32-character string.
To enter licenses:
Start IP Office Manager
1.
2. Select System.
3. The field Dongle Serial Number shows the serial number of the Feature Key Dongle is already detected. Check
that this number matches the one against which the licenses have been issued.
4. Select License.
5. To add a license, click Add... .
6. For the license type select ADI and click OK.
7. Enter the new license key and click OK. We recommend that add licenses by cut and pasting them from a supplied
file listing each 32-character license keys. That avoids potential issues with mistyping.
8. The Status of the new license should show Unknown and name the license as expected. If the name is Invalid,
the most likely cause is incorrect entry of the license key characters.
9. Click on the save icon to send the configuration back to the IP Office.
10.Use IP Office Manager to receive the configuration again and check that the status of the license. It should now be
Valid.
Installing IP500/IP500 V2
IP Office 9.0
license files can be pre-loaded
and receive the configuration from the IP Office system.
70
Initial Configuration Using IP Office Manager:
onto the System SD card. Those
81
.
81
licenses will then be
402
15-601042 Issue 28c (19 August 2013)
Page 103