Like For Like Replacement; Higher Capacity Replacement; Lower Capacity Replacement; Adding A New Component - Avaya IP500 V2 Installation Manual

8.3.1 Like for Like Replacement

If replacing with a component of the same type, no configuration changes are necessary.
To do a like for like replacement
1. Shutdown the system
2. Switch off power to the system.
3. Remove the card or external expansion module. Note the card slot or expansion port used as the replacement must
be installed in the same position.
4. Install the replacement using the appropriate process for the type of component
External Expansion Modules
5. Restart the IP Office system.

8.3.2 Higher Capacity Replacement

If replacing with a component of the same type but higher capacity, when restarted the IP Office will automatically create
configuration entries for the new trunks or extensions/users.
To replace a component with one of the same type but higher capacity
1. Shutdown the system
2. Switch off power to the system.
3. Remove the card or external expansion module. Note the card slot or expansion port used as the replacement must
be installed in the same position.
4. Install the replacement using the appropriate process for the type of component
External Expansion Modules
5. Restart the IP Office system.
6. Use IP Office Manager to configure the new trunks or extensions/users.

8.3.3 Lower Capacity Replacement

If replacing with a component of the same type but lower capacity, after restarting the IP Office the configuration will need
to be edited to remove redundant entries.
To replace a component with one of the same type but lower capacity
1. Shutdown the system
2. Switch off power to the system.
3. Remove the card or external expansion module. Note the card slot or expansion port used as the replacement must
be installed in the same position.
4. Install the replacement using the appropriate process for the type of component
External Expansion Modules
5. Restart the IP Office system.
6. Use IP Office Manager to delete the trunks or extensions/users that are no longer supported by the component
installed.

8.3.4 Adding a New Component

If adding a new component to an available slot or port, when restarted the IP Office will automatically create configuration
entries for the new trunks or extensions/users.
To add a new component
1. Shutdown the system
2. Switch off power to the system.
3. Install the replacement using the appropriate process for the type of component
External Expansion Modules
4. Restart the IP Office system.
5. Use IP Office Manager to configure the new trunks or extensions/users.
Installing IP500/IP500 V2
IP Office 9.0
.
145
).
90
.
145
).
90
.
145
).
90
.
145
).
90
(Fitting IP500 cards ,
83
(Fitting IP500 cards ,
83
(Fitting IP500 cards ,
83
(Fitting IP500 cards ,
83
15-601042 Issue 28c (19 August 2013)
Adding
Adding
Adding
Adding
Page 150