Starting The System - Avaya IP500 V2 Installation Manual

4.11 Starting the System

Control Unit LEDs
The LEDs on the rear of the control unit go through the following sequence during a normal start up. Note that the times
are approximately only:
LED 4s
CPU Orange Green
System SD Orange
Optional SD Orange
If present.
On the front of the control unit, LED1 on any IP500 base cards fitted is used as follows. LED9 is also used for any trunk
daughter cards fitted.
LED
LED1/LED9
Installing IP500/IP500 V2
IP Office 9.0
1. With the IP500 V2 control unit shut down or unpowered, insert the Avaya
System SD card into the System SD slot on the rear of the control unit.
· On newer controls units, the SD card slots are partially covered by a
· Ensure that you have the correct card.
· Ensure that the card has the level of software required. If necessary
2. Apply power to the external expansion modules if any. The power outlet
used must include a switch and in cases where the power cord includes
an earth lead, that outlet must have a protective earth connection.
3. Apply power to the IP500 V2 control unit. The power outlet used must
include a switch and the power outlet must have a protective earth
connection.
4. The control unit will begin loading firmware from the System SD card with
which it will upgrade itself and the components installed in the control
unit.
5. This process takes approximately a minute. The end of this process will
be indicated by LED1 on each base card flashing every 5 seconds. LED9
on each base card fitted with a trunk daughter card will also flash every 5
seconds.
6. The control unit will then begin upgrading the external expansion
modules. This will be indicated by the red center LED on each module
flashing red. The process is completed when the LED changes to steady
green.
7. If a configuration file is already
loaded by the IP Office. If not, the IP Office creates a default
configuration based on the components of the system and copies that
configuration onto the System SD card.
8. It should be possible now to use IP Office Manager to access the
configuration of the IP Office.
4s 12s 5s
Green Green Green
Red
Off Green Green Green
Off Green Green Green
30s
Red
plastic tab. Partial release the screw holding the tab so that it can be
moved clear of the required card slot.
the card can be upgraded to match the version of IP Office Manager
.
79
2s 5s 5s
Green Green
Off Green
Off Off
30s
Red
Fast Flash
present on the System SD
10s 10s
Green Green
Green Green
Flash
Green Green
Flash every 5
15-601042 Issue 28c (19 August 2013)
card it is
81
Finished
Green
Green
Green
Finished
Red
seconds
Page 94