Undo All Settings To Midpos; R & B Convergence Mid - Barco VISION 701 MULTIMEDIA Owner's Manual

SERVICE MODE
ENTER will set all settings to their
midposition.
operation to set all settings to their
midposition.

Undo all settings to midpos

When "All settings to midpos" is
selected, all settings are set to their
midposition. To cancel this action,
select 'Undo all settings to midpos'
by pushing the control disk up or
down and press ENTER. 'Undo all
settings to Midposition' is displayed
in the Memory management menu
in stead off 'All settings to
midposition' when this latter is
pressed.
An undo is possible as long as the
projector is playing on the same
source (= same adjustment block)
even when some adjustments as
geometry or convergence are al-
ready readjusted.
presssed all settings are reset to
the previous settings.
R & B convergence mid
Item is password protected.
Highlight 'R & B convergence mid'
with the control disk and press
ENTER to set all convergence set-
tings to their midposition. A confir-
mation screen will be displayed
first.
R5975228A BARCOVISION 701 MULTIMEDIA 200697
EXIT will cancel the
When undo is
ALL SETTINGS TO MIDPOSITION
All settings
in current block
wil be overwritten !
<ENTER> to confirm
<EXIT> to cancel
MEMORY MANAGEMENT
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
UNDO ALL SETTINGS TO MIDPOS
R & B CONVERGENCE MID
GR CONVERGENCE MID
Select with or
then <ENTER>
<EXIT> to return.
MEMORY MANAGEMENT
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
ALL SETTINGS TO MIDPOS
R & B CONVERGENCE MID
GR CONVERGENCE MID
Select with or
then <ENTER>
<EXIT> to return.
9-15