Barco VISION 701 MULTIMEDIA Owner's Manual page 124

WARNING :
go to
stand by
WARNING :
invalid
frequency
input
table is
deleted
FAILURE
I2C error
addr. : 7FH3
FAILURE
short
circuit on
I2C bus
FAILURE
RCVDS com-
munication
error
FAILURE
IRIS commu-
nication
error
WAIT
starting
up
IRIS
10-4
MESSAGES, WARNINGS AND FAILURES
Projector will switch to 'stand-by' when the RCVDS is no
longer available.
The entered frequency or applied frequency of the
source is out of the projector's range.
Message to inform that selected table is deleted. This
message will be followed by 'confirm message', on which
the user has to answer.
Hardware failure. Call a qualified service technician for
repair.
Hardware failure. Call a qualified service technician for
repair.
Serial communication error between the RCVDS and
the projector.
Communication error between IRIS 800 and the projec-
tor. Call a qualified service technician.
Message during the start up of the IRIS 800. Message
will disappear when the IRIS 800 is ready to accept
commands.
R5975228A BARCOVISION 701 MULTIMEDIA 200697