Change Projector Address; Change Baudrate - Barco VISION 701 MULTIMEDIA Owner's Manual

Change Projector Address

Every projector requires an individual
address between O and 255. This
address can be software installed.
To change that address, push the
control disk up or down to highlight
'Change Porjector Address' and press
ENTER. The Change Projector Ad-
dress menu will be displayed and the
actual address will be filled in.
The first digit is highlighted. Select
the individual digits by pushing the
control disk to the right or to the left.
Reprogram with the digit keys on the
RCU.
Press ENTER to confirm.
Press EXIT to return to the projector
set up menu.

Change baudrate

The communication speed between
projector and computer has 8 pos-
sible speeds. The baud rate speed
can be software set up.
Highlight 'Change Baudrate' by
pushing the control disk up or down
and press ENTER to display the
Baud rate menu.
9-8
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
Select with
then <ENTER>
<EXIT> to return.
ENTER displays the 'Change Projector
Address' menu.
EXIT returns to the Service mode main
menu.
PROJECTOR ADDRESS
Enter new projector
address :
0 0 0
Use and
and reprogram
with numeric keys.
Highest address is 255
<ENTER> to confirm
<EXIT> to return.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
Select with
then <ENTER>
<EXIT> to return.
R5975228A BARCOVISION 701 MULTIMEDIA 200697
SERVICE MODE
or
to select,
or