Service Mode
All settings to midposition
What can be done ?
All adjustment settings (geometry and convergence) can be set to mid position.
Item is password protected.
How to set to midposition ?
1. Push the cursor key é or ê to highlight All Settings to Midposition (menu 1).
2. Press ENTER to select.
A confirmation menu will be displayed first (menu 2).
3. Press ENTER to confirm.
Press EXIT to cancel the operation 'set all settings to their midposition'.
SERVICE MODE
IDENTIFICATION
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
MORE ...
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
Undo all settings to midpos
What can be done ?
'Undo all settings to Midposition' is displayed in the Memory management menu in stead off 'All settings to midposition' when this latter
is pressed.
An undo is possible as long as the projector is running on the same source (= same adjustment block) even when some adjustments
as geometry or convergence are already readjusted. When undo is presssed all settings are reset to the previous settings.
How to cancel 'Set to midposition' ?
When "All settings to midpos" is selected, all settings are set to their midposition. To cancel this action :
1. Push the cursor key é or ê to highlight 'Undo all settings to midpos' (menu 1).
2. Press ENTER to cancel the set to midposition action.
SERVICE MODE
IDENTIFICATION
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
UNDO ALL SETTINGS TO MID
CONVERGENCE MID
MORE ...
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
Convergence mid
What can be done ?
All convergence settings for red and blue are set to midposition.
Item is password protected.
8-6
SET TO MIDPOSITION
All settings
on current block
will be overwritten !
<ENTER> to confirm
<EXIT> to cancel
menu 2
5976227 BARCOCINE 8 13042001