Deletion Of All Blocks; All Settings To Midposition; Undo All Settings To Midpos - Barco R9002120 Owner's Manual

Deletion of all blocks

Highlight 'delete all blocks' with the control disk and press ENTER .
ENTER gives a confirmation message before deleting.
EXIT returns to the Path Selection main menu.
If you are certain you wish to delete all blocks, press ENTER to
confirm, otherwise press EXIT to return.
Once ENTER is pressed, all block headers and adjustment settings
are permanently removed and cannot be restored.

All settings to midposition

Item is password protected.
Highlight 'All settings to midposition' with the control disk and press
ENTER to set all settings to their midposition.
A confirmation menu will be displayed first.
ENTER displays a Confirmation screen.
EXIT returns to the Service menu.
ENTER will set all settings to their midposition. EXIT will cancel the
operation to set all settings to their midposition.

Undo all settings to midpos

When "All settings to midpos" is selected, all settings are set to their
midposition. To cancel this action, select 'Undo all settings to
midpos' by pushing the control disk up or down and press ENTER.
'Undo all settings to Midposition' is displayed in the Memory man-
agement menu in stead off 'All settings to midposition' when this
latter is pressed.
An undo is possible as long as the projector is playing on the same
source (= same adjustment block) even when some adjustments as
geometry or convergence are already readjusted. When undo is
presssed all settings are reset to the previous settings.
5975977 BARCODATA 708 260597
Service Mode
MEMORY MANAGEMENT
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
ALL SETTINGS TO MIDPOS
R & B CONVERGENCE MID
GR CONVERGENCE MID
Select with or
then <ENTER>
DELETE ALL BLOCK
<EXIT> to return.
All block
will be deleted !
<ENTER> to confirm
<EXIT> to cancel
MEMORY MANAGEMENT
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
ALL SETTINGS TO MIDPOS
R & B CONVERGENCE MID
GR CONVERGENCE MID
Select with or
then <ENTER>
SET TO MIDPOSITION
<EXIT> to return.
All settings
on current block
will be overwritten !
<ENTER> to confirm
<EXIT> to cancel
MEMORY MANAGEMENT
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
UNDO ALL SETTINGS TO MIDPOS
R & B CONVERGENCE MID
GR CONVERGENCE MID
Select with
then <ENTER>
<EXIT> to return.
or
7 - 7