Table of Contents
Advertisement
Deletion of all blocks
What can be done ?
All blocks (all settings) can be deleted at the same time.
How to delete all blocks ?
1. Push the cursor key é or ê to highlight Delete all Blocks (menu 1).
2. Press ENTER to select.
A confirmation screen will be displayed (menu 2).
3. Press ENTER to confirm
Press EXIT to return without deleting any block.
Once ENTER is pressed, all block headers and adjustment settings are permanently removed and cannot be restored.
MEMORY MANAGEMENT
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
ALL SETTINGS TO MIDPOS
R & B CONVERGENCE MID
GR CONVERGENCE MID
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
All settings to midposition
What can be done ?
All adjustment settings (geometry and convergence) can be set to mid position.
Item is password protected.
How to set to midposition ?
1. Push the cursor key é or ê to highlight All Settings to Midposition (menu 1).
2. Press ENTER to select.
A confirmation menu will be displayed first (menu 2).
3. Press ENTER to confirm.
Press EXIT to cancel the operation 'set all settings to their midposition'.
MEMORY MANAGEMENT
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
ALL SETTINGS TO MIDPOS
R & B CONVERGENCE MID
GR CONVERGENCE MID
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
Undo all settings to midpos
What can be done ?
'Undo all settings to Midposition' is displayed in the Memory management menu in stead off 'All settings to midposition' when this latter
is pressed.
An undo is possible as long as the projector is running on the same source (= same adjustment block) even when some adjustments
as geometry or convergence are already readjusted. When undo is presssed all settings are reset to the previous settings.
5976197 BARCOCINE 7 10012001
DELETE ALL BLOCK
All block
will be deleted !
<ENTER> to confirm
<EXIT> to cancel
menu 2
SET TO MIDPOSITION
All settings
on current block
will be overwritten !
<ENTER> to confirm
<EXIT> to cancel
menu 2
Service Mode
8-9
Advertisement
Table of Contents
