Power Up Mode - Barco VISION 701 MULTIMEDIA Owner's Manual

SERVICE MODE
The following baud rates are avail-
able :
- 9600
- 4800
- 2400
- 1200
- 600
- 300
- 150
- 110
The actual baud rate will be high-
lighted. To change the baud rate,
push the control disk up or down
or to the left or to the right to select
the desired baud rate and press
ENTER to accept this baud rate.

Power up mode

When pressing the power switch,
the projector can start up in 'oper-
ating mode' or in 'stand-by mode'.
Operating mode : the projector start
up and displays image .
Stand-by mode : the projector start
up in stand-by and waits until the
stand-by button or a digit key is
pressed.
To change the Power up mode,
select Power Up mode by pushing
the control disk up or down and
press ENTER to toggle between
'Operating' and 'Standby'.
R5975228A BARCOVISION 701 MULTIMEDIA 200697
BAUDRATE
Select new
baudrate :
9600
2400
600
150
Select with arrow
keys ;
<ENTER> to accept
<EXIT> to return.
ENTER to accept the selected baud
rate.
EXIT to return without changing the
baud rate.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE :
BARCO LOGO
Select with
then <ENTER>
<EXIT> to return.
ENTER to toggle between operating and
standby.
EXIT to return to the Service menu.
4800
1200
300
110
operating
or
9-9