Barco VISION 701 MULTIMEDIA Owner's Manual page 133

APPENDIX B : ORBITING
Orbiting speed toggle (only in MASTER Orbiting)
Highlight 'SPEED : SLOW' with
the coontrol disk and press EN-
TER to set the ORBITING SPEED
to Fast.
Highlight 'SPEED : FAST' with the
control disk and press ENTER to
set the ORBITING SPEED to Slow
Orbiting alignment
Preparation :
Before proceeding to the alignment of the Orbiting default settings, be sure that
the Horizontal Phase and the Raster shift are correctly aligned with the Orbiting
mode set to OFF.
This alignment must be performed in case of a multiple projector installation with
Master and Slave projectors in order to ensure a correct operation of the Orbiting
for all projectors.
Adjustment procedure stand alone projector :
Highlight 'ADJUST DEVIATION'
with the control disk and press
ENTER.
R5975238A BARCOVISION 701 MULTIMEDIA 200697
MASTER ORBITING
CHANGE TO SLAVE
MODE: ON
SPEED: FAST
ADJUST DEVIATION
SELECT WITH
THEN <ENTER>
DEVIATION ADJUST :
VERTICAL WITH
HORIZONTAL WITH
<EXIT> to return
ENTER continues to Set up Orbiting.
EXIT returns to the Path Selection menu.
ADJUST returns to the Operational mode.
MASTER ORBITING
CHANGE TO SLAVE
MODE: ON
SPEED: FAST
ADJUST DEVIATION
SELECT WITH
THEN <ENTER>
DEVIATION ADJUST :
VERTICAL WITH
HORIZONTAL WITH
<EXIT> to return
OR
OR
OR
OR
OR
OR
B-3