Switching On/Off; Power (Mains) Cord Connection - Barco VISION 701 MULTIMEDIA Owner's Manual

Power (mains) cord connection

Use the supplied power cord to connect your projector to the wall outlet. Plug the
female power connector into the male connector at the front of the projector.

Switching on/off

The projector is switched ON and OFF using the power (mains) switch ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start now in the 'operational mode' (image displayed) or in the
'stand by mode', depending on the position of the 'power up' dip switch on the
controller unit. This DIP switch is set during installation by a qualified technician.
If you want to change this start up mode, call a qualified technician.
Stand by indication lamp :
no light up : projector in operational mode
red : projector is in stand by.
Leds on the front plate of the projector
3-2
POWER CONNECTION
See installation instructions before
connecting to the supply
V NOM 120 Volt
I MAX
FREQ 60 Hz
OFF ON
R5975238A BARCOVISION 701 MULTIMEDIA 200697
See installation instructions before
connecting to the supply
V NOM 120 Volt
I MAX 5 AMP
FREQ 60 Hz
OFF ON
5 AMP