How To Program An Address Into The Rcu; Input Selection - Barco VISION 701 MULTIMEDIA Owner's Manual

How to program an address into the RCU?

Press the ADDRESS key (recessed key on the RCU) with a pencil and enter the
address with the digit buttons. That address can be any digit between 0 and 9.
When programming '0', zero address, the RCU will control a projector regardless of
the projector's address.
addresses to be controlled by a single RCU.

Input selection

Source No Projector input
Two possible ways of selecting an input :
a) With the digit buttons on the RCU, it is possible to select one of the four input
sources, Video, S-Video, RGsB or RGBS, RG3sB or RGB3S, (R-Y)Ys(B-Y) or
(R-Y)Y(B-Y)S, (R-Y)Y3s(B-Y) or (R-Y)Y(B-Y)3S.
b) With the local keypad :
press first the ADJUST key to display the
General access menu.
5-6
This feature allows multiple projectors with different
1 Comp. Video
2 S-Video
3 RGBS or RGsB
4 RGB3S or RG3sB
5 (R-Y)Y(B-Y)S or
6 (R-Y)Y(B-Y)3S or
(R-Y)Ys(B-Y)
(R-Y)Y3s(B-Y)
R5975238A BARCOVISION 701 MULTIMEDIA 200697
CONTROLLING
Press digit button
1
2
3
4
5
6
ADJUST EXIT
STANDBY
ENTER