Crt Run In Cycle - Barco VISION 701 MULTIMEDIA Owner's Manual

SERVICE MODE

CRT run in cycle

The CRT run in cycle option can only be activated when memory blocks on an internal
# pattern are available. When one or more such blocks are available, a flashing white
image (5sec on, 5 sec off) is generated and that for 5 min on the first internal block.
In the next 5 min, a second internal block will be used to generate the flashing white
image. The image will also be shifted in a vertical way to prevent a CRT burn in. To
quit the CRT run in cycle option, press EXIT.
Highlight 'CRT run in cycle' with
the control disk and press EN-
TER to start.
If a memory block adjusted on an
internal # pattern is available, the
CRT run in cycle will start when
pressing ENTER. If no such a block
is available, the projector cannot
run the CRT run in option and leaves
the adjustment mode.
If you still want to run CRT run in
cycle, create first a memory block
on an internal # pattern and restart
the CRT run in option.
R5975228A BARCOVISION 701 MULTIMEDIA 200697
COMMON SETTINGS
G2 ADJUSTMENT
CRT RUN IN CYCLE
PROJECTOR WARM UP
Select with
then <ENTER>
<EXIT> to return.
ENTER selects the CRT run in cycle option.
EXIT returns to the Path Selection main
menu.
CRT RUN IN CYCLE
A flashing white pattern
will be generated until
<EXIT> is pressed.
The projector only uses
memory blocks adjusted
on an internal # pattern;
if no such block is
available, the projector
can't run the procedure
and leaves the adjustment
mode.
<ENTER> to continue
<EXIT> to cancel
ENTER starts the 'CRT run in' when an
internal generated # pattern is available.
EXIT returns to the Path Selection main
menu.
or
9-19