Barco VISION 701 MULTIMEDIA Owner's Manual page 32

Battery installation in the RCU.
A new battery is delivered inside the plastic bag with
the power cord. Before using the RCU, install first the
battery.
Remove the battery cover on the backside of the
remote control by pushing the indicated handle a little
to the bottom of the RCU. Lift up the top side of the
cover at the same time (fig. 1).
Insert the new 9 V battery (E-block type, e.g. 6F22S or
equivalent) in the lower compartment and connect the
battery to the contact plate.
Insert the battery into the lower compartment and put
the cover back.
5-2
Contact
plate
Battery
R5975238A BARCOVISION 701 MULTIMEDIA 200697
CONTROLLING
Insert here,
behind the
plastic cover, the
'Insert card for
RCU'. You can
cut out the
correct insert
card on one of
the last pages of
this manual.
fig.2
310a.DRW
fig.1