Connection - Icom VE-PG3 Instruction Manual

3
CONVERTER MODE APPLICATION
2. Using an in-house sound system (continued)

2. Connection

Set the transceiver channel, volume level, TX output power, and other necessary settings, before connecting to the
VE-PG3.
NOTE:
• Verify that both the radio and the VE-PG3 are turned OFF when connecting or disconnecting the transceiver.
• Keep the radio away from a PC, AC adaptor and other electronic equipment. The noise emitted from those equipment
may interfere with the radio.
• When operating the radio, do not transmit near the IP telephone.
1
Connect the VE-PG3 and the transceiver, using the OPC-2775 cable.
To [TRX1] (Upper slot)
A A B C
• The [TRX1] and [TRX2] ports (upper slots) accept the OPC-2275 connectors.
However, follow the example to correctly connect the transceiver to ONLY the [TRX1] slot.
2
Make a cable the length you need, with an supplied connector wired as shown, and the appropriate connec-
tor for your audio device. Then connect it to the [EXT1] on the VE-PG3 and then to your audio device.
• See Section 8 for port details.
3
When all the connections are completed, turn ON the transceiver and VE-PG3's power.
VE-PG3 (Rear view)
PHONE
A B C
OPC-2275
To EXT1 (lower slot)
A
1 2 3 4
LINE2 LINE1
To the external speaker jack
Be sure to insert the
connectors top side up.
A
1 2 3 4
Top
Bottom
A
A1: Audio output (OUT)
A2: Audio output ground
A3: Audio input (IN)
1 2 3 4
A4: Audio input ground
A1 A2 A3 A4
3-8
Icom's transceiver
(IC-F5060/IC-F6060 series) (Rear view)
(Front view)
To the microphone connector