Icom VE-PG3 Instruction Manual page 259

6
CONVERTER MODE SETTING SCREEN
9. [Port Settings] Menu
M Transceiver Control (continued)
**
*
*
!5
!6
* Appears only when "DTMF" is selected in [PTT Control Type from the Telephone].
** Appears only when "IC-FR5000/FR6000" or "General" is selected in [Transceiver Model].
t RX Volume ..................
y Transceiver's Beep Invalidity Time
Notice Tone to the Transceiver
u Reception Notice ............
i Calling Notice Tone .........
o Send Connect Success Tone
!0 Disconnect Notice Tone ...
[Port Settings]–[Transceiver 1 (TRX1)/[Transceiver 2 (TRX2)]
Adjust the VE-PG3's audio input level of the audio signal that is received from
the connected transceiver between "+6" to "–12" (dB).
Enter the time period to mute the audio (including beep sounds) from the
connected radio.
Range: "0" to "1000" (in 5 milliseconds step)
Select "Notice Tone 1" to "Notice Tone 3" to notify that the call from an IP
phone is received.
Select "Notice Tone 1" to "Notice Tone 3" to notify the calling to an IP phone.
Select "Notice Tone 1" to "Notice Tone 3" to notify that the IP phone's
handset is picked up.
Select "Notice Tone 1" to "Notice Tone 3" to notify that the IP phone's
handset is put.
6-73
(Default: 0)
(Default: 400)
(Default: Not used)
(Default: Notice Tone 2)
(Default: Notice Tone 2)
(Default: Notice Tone 3)