Icom VE-PG3 Instruction Manual page 255

6
CONVERTER MODE SETTING SCREEN
9. [Port Settings] Menu (continued)
M Transceiver 1 (TRX1)/Transceiver 2 (TRX2)
1
*
!2
!3
!4
2
*
!5
!6
!7
!8
!9
@0
3
*
@1
@2
1
* Appears only when "Enable" is selected in [Power Detection].
2
* Appears only when "Enable" is selected in [Serial Communication].
3
* Appears only when "Manual" is selected in [Data Mode].
!7 Data Mode .....................
!8 Baud Rate .....................
!9 Data Bits..................................
@0 Parity........................................
@1 Stop Bits..................................
[Port Settings]–[Transceiver 1 (TRX1)/[Transceiver 2 (TRX2)]
[Data Mode] selects the communication method for the Serial Communication
between a device and the VE-PG3.
• Auto: Automatically starts the serial communication from a Virtual Serial Port
installed on your PC.
• Manual: Manually sets a serial communication method for a device.
* [Baud Rate] (!8 ) – [Session Timer] (@2 ) are displayed when
"Manual" is selected.
Select a serial communication speed between a device and the VE-PG3.
Select the number of bits for the serial communication between 5 and 8.
Select a parity bit of "none," "odd," or "even."
Select the stop bit length for the data of 1 or 2.
6-69
"NXDN Conventional"
@3
@4
@5
@6
@8
"NXDN Trunking"
@3
@4
@7
@5
@6
@8
@9
"dPMR"
@3
@4
#0
Client Mode:Enable
#1
#2
#3
(Default: Auto)
(Default: 9600)
(Default: 8)
(Default: none)
(Default: 1)