Connection - Icom VE-PG3 Instruction Manual

3
CONVERTER MODE APPLICATION
1. Communication in the Peer to Peer mode (continued)

2. Connection

Set the transceiver channel, volume level, TX output power, and other necessary settings, before connecting to the
VE-PG3.
NOTE:
• Verify that both the radio and the VE-PG3 are turned OFF when connecting or disconnecting the transceiver.
• Keep the radio away from a PC, AC adaptor and other electronic equipment because the noise emitted from them may
interfere with the radio.
• When operating the radio, do not transmit near an IP telephone.
1
Connect the VE-PG3 and the transceiver using the OPC-2275 cable.
To [TRX1] (Upper slot)
• The [TRX1] and [TRX2] ports (upper slots) accept the OPC-2275 connectors.
However, follow the example to correctly connect the transceiver to ONLY the [TRX1] slot.
2
When all the connections are completed, turn ON the transceiver and VE-PG3's power.
VE-PG3 (Rear view)
A B C
A A B C
OPC-2275
PHONE LINE2 LINE1
Be sure to insert the
connectors top side up.
A
1 2 3 4
Top
Bottom
3-3
Icom's transceiver
(IC-F5060/IC-F6060 series)
To the external speaker jack
(Front view)
To the microphone connector
(Rear view)