M Bridge Control - Icom VE-PG3 Instruction Manual

6
CONVERTER MODE SETTING SCREEN
9. [Port Settings] Menu (continued)

M Bridge Control

Configure the details for bridge-connected device.
*
*
!3
!4
*Appears when "G.711u Signaling" is selected in the [Voice Coding] item.
q Priority Receive ............
w PTT Cancel ..................
e Target Availability Check ...
r Timing of
Target Availability Check ...
Notice Tone to the Transceiver
t Reception Notice ............
y Calling Notice Tone .........
u Send Connect Success Tone
Select "Enable" to keep receiving, even if the transceiver detects audio from
the SIP phone.
Select "Enable" to abort the calling to an IP phone when a transmit request is
detected.
Select "Disable" to skip the communication availability check. (Default: Enable)
If "Enable" is selected, the VE-PG3 disconnects the communication route
when a call (except Emergency call) from telephone to IP1000C is failed.
The availability check fails when the called IP100H is busy, or no response is
received (Time out timer: 5 seconds).
Select "Before" to execute the Target Availability Check (e) before the
communication route is established.
Select "Tone 1" to "Tone 3" to notify that the call from an IP phone is received.
Select "Tone 1" to "Tone 3" to notify the calling to an IP phone.
Select "Tone 1" to "Tone 3" to notify that the IP phone's handset is taken off.
6-116
[Port Settings]–[Bridge 1–Bridge 4]
(Default: Enable)
(Default: Disable)
(Default: After)
(Default: Not used)
(Default: Notice Tone 2)
(Default: Notice Tone 2)