M Ext Control Terminal - Icom VE-PG3 Instruction Manual

6
CONVERTER MODE SETTING SCREEN
9. [Port Settings] Menu (continued)

M EXT Control Terminal

Set the details of the control signal from the [EXT1]/[EXT2] port.
Note: Appears only when "Control Data Detection" is selected in [Valid Timing].
*
y
*Appears only when "One-shot" is selected in [Input Type].
q Input Type .....................
w Event ON Time ...............
[Port Settings]–[EXT Input 1 (EXT1)/EXT Input 2 (EXT2)]
Select the when the control signal is input.
• Momentary
While the control signal is input from the B3/B4 terminal (General control
port), activates the port.
• One-shot
When the control signal is input from the B3/B4 terminal (General control
port), continuously activates the port. And deactivates with no input.
Select the delay time until the input is detected.
6-98
(Default: Momentary)
(Default: 1)