Connection - Icom VE-PG3 Instruction Manual

2
BRIDGE MODE APPLICATION
4. Operating in the NXDN Conventional mode (continued)

3. Connection

Set the transceiver channel, volume level, TX output power, and other necessary settings, before
connecting to the VE-PG3.
1
Connect the VE-PG3 and the transceiver, using the appropriate optional cable.
• Verify that both the VE-PG3 and the transceiver are turned OFF when connecting the cable.
To [TRX1] (Upper slots)
A A B C
• The [TRX1] and [TRX2] ports (upper slots) accept the OPC-2275 connectors,
however, follow the example to correctly connect the transceiver to ONLY the [TRX1] on the VE-PG3.
2
When all the connections are finished, turn ON the transceiver and VE-PG3's power.
NOTE:
• Verify that both the radio and the VE-PG3 are turned OFF when connecting or disconnecting the transceiver.
• Keep the radio away from a PC, AC adaptor and other electronic equipment. The noise emitted from those equipment may
interfere with the radio.
• When operating the radio, do not transmit near the IP telephone.
VE-PG3 (Rear view)
LINE2 LINE1
PHONE
Be sure to insert the
A B C
connectors top side up.
OPC-2275
Icom's transceiver
(IC-F5060/IC-F6060 series)
To the external speaker jack
A
1 2 3 4
Top Bottom
2-13
(Rear view)
(Front view)
To the microphone connector