M Bridge Communication - Icom VE-PG3 Instruction Manual

5
BRIDGE MODE SETTING SCREEN
8. [Port Settings] Menu (continued)

M Bridge Communication

Configure the encryption of Bridge communication.
*
* Appears when "Enable" is selected in [Default Callee ID].
q Encryption .....................
w Default Callee ID ............
e Call Type .....................
r Destination Prefix ID ......
t Destination ID ...............
y My Station Prefix ID .........
u My Station ID ...............
Select "Enable" to encrypt the communication.
• When you select "Enable," enter the appropriate key to [Encryption Key].
Note: This setting takes effect when AMBE+2 codec is used.
Select "Enable" to apply the ID to the TX signal.
• When you select "Enable," enter the IDs in the bellow items.
Select the type of call.
• Individual :Call only specified radio.
• Group :Call all radios that belong to the specified group.
• All :Call all radios.
Enter the destination prefix ID in two digits.
ID range: (Depending on the system mode)
Enter the destination ID in four digits.
ID range: (Depending on the system mode)
Enter the station prefix ID in two digits.
ID range: (Depending on the system mode)
Enter the station ID in four digits.
ID range: (Depending on the system mode)
5-104
[Port Settings]–[Emergency Notice]
(Default: Disable)
(Default: Disable)
(Default: Group)
(Default: 1)
(Default: 1)