Configuring An Snmp Community - HP 1920 Gigabit Ethernet Switch Series User Manual

Figure 105 Adding rules to an SNMP view
4. Configure the parameters as described in
5. Click Apply.
NOTE:
You can also click the
and then you can enter the page to modify the view.

Configuring an SNMP community

1. Select Device > SNMP from the navigation tree.
2. Click the Community tab.
The Community tab appears.
Figure 106 Configuring an SNMP community
3. Click Add.
The Add SNMP Community page appears.
icon corresponding to the specified view on the page as shown in
117
Table 34.
Figure 102,