HP 1920 Gigabit Ethernet Switch Series User Manual page 23

Function menu
Switch To
Management
Loopback Loopback
VCT VCT
Flow Port Traffic
Interval Statistics
Statistics
History
RMON
Alarm
Event
Log
Energy
Energy Saving
Saving
Setup
Community
Group
SNMP
User
Trap
View
Interface Interface
Statistics Statistics
Description
Switch the current user level to the management
level.
Perform loopback tests on Ethernet interfaces.
Check the status of the cables connected to Ethernet
ports.
Display the average rate at which the interface
receives and sends packets within a specified time
interval.
Display, create, modify, and clear RMON
statistics.
Display, create, modify, and clear RMON history
sampling information.
Display, create, modify, and clear alarm entries.
Display, create, modify, and clear event entries.
Display log information about RMON events.
Display and configure the energy saving settings of
an interface.
Display and refresh SNMP configuration and
statistics information.
Configure SNMP.
Display SNMP community information.
Create, modify, and delete an SNMP community.
Display SNMP group information.
Create, modify, and delete an SNMP group.
Display SNMP user information.
Create, modify, and delete an SNMP user.
Display the status of the SNMP trap function and
information about target hosts.
Enable or disable the SNMP trap function; create,
modify, and delete a target host.
Display SNMP view information.
Create, modify, and delete an SNMP view.
Display and clear the statistics information about
an interface.
10
User level
Visitor
Configure
Configure
Monitor
Configure
Configure
Configure
Configure
Configure
Configure
Monitor
Configure
Monitor
Configure
Monitor
Configure
Monitor
Configure
Monitor
Configure
Monitor
Configure
Configure