Displaying The Ipv6 Active Route Table; Creating An Ipv6 Static Route - HP 1920 Gigabit Ethernet Switch Series User Manual

Item
Interface

Displaying the IPv6 active route table

Select Network > IPv6 Routing from the navigation tree to enter the page.
Figure 256 IPv6 active route table
Table 92 Field description
Field
Destination IP Address
Prefix Length
Protocol
Preference
Next Hop
Interface

Creating an IPv6 static route

1. Select Network > IPv6 Routing from the navigation tree.
2. Click the Create tab.
Description
Select the output interface.
You can select any available Layer 3 interface, for example, a virtual interface, of
the device. If you select NULL 0, the destination IP address is unreachable.
Description
Destination IP address and prefix length of the IPv6 route.
Protocol that discovered the IPv6 route.
Preference value for the IPv6 route.
The smaller the number, the higher the preference.
Next hop IP address of the IPv6 route.
Output interface of the IPv6 route. Packets destined for the specified network
segment are sent out of the interface.
281