Configuring Switch B; Verifying The Configuration - HP 1920 Gigabit Ethernet Switch Series User Manual
Hp 1920 gigabit ethernet switch series
Hide thumbs
Also See for 1920 Gigabit Ethernet Switch Series:
- User manual (547 pages) ,
- Getting started manual (33 pages) ,
- Supplementary manual (63 pages)
Table of Contents
Advertisement
Configuring Switch B
1.
(Optional.) Enable LLDP on port GigabitEthernet 1/0/1. By default, LLDP is enabled on Ethernet
ports.
2.
Set the LLDP operating mode to Tx on GigabitEthernet 1/0/1:
a.
From the navigation tree, select Network > LLDP.
By default, the Port Setup tab is displayed.
b.
Click the
c.
Select Tx from the LLDP Operating Mode list.
3.
Click Apply.
A progress dialog box appears.
4.
Click Close on the progress dialog box when the progress dialog box prompts that the
configuration succeeds.
Figure 212 Setting the LLDP operating mode to Tx
5.
Enable global LLDP:
a.
Click the Global Setup tab.
b.
Select Enable from the LLDP Enable list.
6.
Click Apply.
A progress dialog box appears.
7.
Click Close on the progress dialog box when the progress dialog box prompts that the
configuration succeeds.
Verifying the configuration
1.
Display the status information of port GigabitEthernet 1/0/1 on Switch A:
a.
From the navigation tree, select Network > LLDP.
By default, the Port Setup tab is displayed.
icon for port GigabitEthernet 1/0/1.
239
Hide quick links:
Advertisement
Table of Contents
