Link Aggregation And Lacp Configuration Example - HP 1920 Gigabit Ethernet Switch Series User Manual

Field
Partner Port
Partner Port State
Oper Key
Table 68 Field description
Field
Unit
Port
Partner ID
Partner Port Priority
Partner Oper Key

Link aggregation and LACP configuration example

Network requirements
As shown in
incoming and outgoing traffic across the member ports.
Figure 192 Network diagram
Method 1: Create static link aggregation group 1
1. From the navigation tree, select Network > Link Aggregation.
2. Click Create.
3. Configure static link aggregation group 1:
Description
ID of the peer port.
States of the peer port:
•
A—LACP is enabled.
•
B—LACP short timeout. If B does not appear, it indicates LACP long timeout.
•
C—The sending system considers the link is aggregatable.
•
D—The sending system considers the link is synchronized.
•
E—The sending system considers the incoming frames are collected.
•
F—The sending system considers the outgoing frames are distributed.
•
G—The sending system receives frames in the default state.
•
H—The sending system receives frames in the expired state.
Operational key of the local port.
Figure 192, create a link aggregation group on Switch A and Switch B to load-share
Description
Number of the remote system.
Name of the remote port.
LACP priority and MAC address of the remote system.
LACP priority of the remote port.
Operational key of the remote port.
213