Figure 29 Device summary (a member device)
Stack configuration example
Network requirements
As shown in
Create a stack, where Switch A is the master device, and Switch B, Switch C, and Switch D are member
devices. An administrator can log in to Switch B, Switch C, and Switch D through Switch A to perform
remote configurations.
Figure 30 Network diagram
Configuration procedure
1.
Configure global parameters for the stack on Switch A:
a.
Select Stack from the navigation tree of Switch A, and then perform the subsequent steps on the
Setup tab, as shown in
b.
Type 192.168.1.1 in the field of Private Net IP.
c.
Type 255.255.255.0 in the field of Mask.
d.
Select Enable from the Build Stack list.
e.
Click Apply.
Figure
30, Switch A, Switch B, Switch C, and Switch D are connected to one another.
Figure
31.
43