Setting Lldp Parameters On Ports; Setting Lldp Parameters For A Single Port - HP 1920 Gigabit Ethernet Switch Series User Manual

Setting LLDP parameters on ports

The Web interface allows you to set LLDP parameters for a single port or for multiple ports in batch.

Setting LLDP parameters for a single port

1. From the navigation tree, select Network > LLDP.
By default, the Port Setup tab is displayed.
2. Click the
On the page as shown in
Figure 199 Modifying LLDP settings on a port
3. Configure the LLDP parameters for the port as described in
4. Click Apply.
A progress dialog box appears.
5. Click Close on the progress dialog box when the progress dialog box prompts that the
configuration succeeds.
Table 75 Configuration items
Item
Interface Name
DLDP State
Basic
Settings
icon for the port.
Figure 199, the LLDP settings of the port are displayed.
LLDP Operating Mode
Description
Displays the name of the port or ports you are configuring.
Displays the LLDP enabling status on the port you are configuring.
This field is not available when you batch-configure ports.
Set the LLDP operating mode on the port or ports you are
configuring:
•
TxRx—Sends and receives LLDP frames.
•
Tx—Sends but does not receive LLDP frames.
•
Rx—Receives but not does not send LLDP frames.
•
Disable—Neither sends nor receives LLDP frames.
224
Table 75.