HP 1920 Gigabit Ethernet Switch Series User Manual page 439

The page for applying port security control appears.
Figure 412 Configuring basic port security control
3. Configure basic port security control settings as described in
4. Click Apply.
Table 129 Configuration items
Item
Port
Max Number of MAC
Enable Intrusion Protection
Description
Selects a port where you want to configure port security.
By default, port security is disabled on all ports, and access to the ports is not
restricted.
Sets the maximum number of secure MAC addresses on the port.
The number of authenticated users on the port cannot exceed the specified upper
limit.
You can set the maximum number of MAC addresses that port security allows on
a port for the following purposes:
•
Control the maximum number of concurrent users on the port.
•
Control the number of secure MAC addresses that can be added with port
security.
NOTE:
The port security's limit on the maximum number of MAC addresses on a port is
independent of the MAC learning limit in MAC address table management.
Specifies whether to enable intrusion protection, and selects an action to be
taken on illegal frames.
Available actions:
•
Disable Port Temporarily—Disables the port for a period of time. The period
can be configured in the global settings. For more information, see
"Configuring global settings for port
•
Disable Port Permanently—Disables the port permanently upon detecting an
illegal frame received on the port. The port does not come up unless you bring
it up manually.
•
Block MAC—Adds the source MAC addresses of illegal frames to the blocked
MAC addresses list and discards the frames. All subsequent frames sourced
from a blocked MAC address will be dropped. A blocked MAC address is
restored to normal state after being blocked for 3 minutes. The interval is not
user configurable.
426
Table 129.
security."