Table of Contents
Advertisement
Advanced Graphic Data Manager
"Printout" menu items
Current measured values
Screenshot
"Set points" menu
items
Submenu: Set point x
This is used to change the set point during operation.
Channel
Type
Range start
Only with analog channels
Meas. range end
Only with analog channels
Print out instantaneous measured values (all active channels).
Print out current measured value display (screenshot).
6.5.11
Extras - Screenshot
Save the current measured value display as a bitmap on the SD card or the USB stick.
This function is not available if no SD card or USB stick is plugged into the unit. If an SD
card and a USB stick is plugged into the unit, the screenshot is only saved onto the USB
stick.
6.5.12
Extras - Set points
Here, you can change set points during operation. In this way, the set points can be changed outside
the actual setup. The advantage is that all the other parameters cannot be changed in this way. A
list with all the set points currently set is displayed. To change a limit value, select the desired limit
value from the list. Function is only visible if "Also in menu Extras" is selected under in "Main menu
-> Setup -> Application -> Change set points.
When user administration is activated ("Setup –> System –> Security –> Protected by:
"FDA 21 CFR Part 11"), this function is only available if a user is logged on and this user
has the necessary rights.
Fig. 72:
Extras "Set points"
Description
(factory settings are highlighted in bold)
Configurable parameters
(factory settings are highlighted in bold)
Displays the channel assigned to the set point selected. Cannot be changed.
Displays the type assigned to the set point selected (e.g. upper set point). Cannot be
changed.
Displays the start of measuring range for the selected channel. Cannot be changed.
Displays the end of measuring range for the selected channel. Cannot be changed.
Commissioning and use during operation
95
Advertisement
Table of Contents
