Table of Contents
Advertisement
Advanced Graphic Data Manager
"System" menu
items
Language
Select unit operating language. Factory setting: English
Device tag
Individual unit identifier (max. 22 characters). Factory setting: Device 1
Is also saved on the SD card.
Decimal separator
Select in which form the decimal separator character is to be displayed.
Picklist: comma, point
Temp. unit
Selection of temperature units. All directly connected thermocouples or resistance thermometers (RTD) are
displayed in the preset engineering units. Picklist: °C, °F, K
LED mode
"Namur NE44": Green LED -> power supply OK.
(only in the Expert
Red LED –> Measuring signal failure.
mode)
Red LED flashing –> Maintenance required.
"Namur NE44+": see above, + red LED in event of limit violation
PRESET
Returns all parameters to the factory default setup.
(only in the Expert
Risk of data loss!
mode)
Save needed data previously on SD card!
PRESET only appears once the service code has been entered.
Device operational
This relay is switched as soon as the device is fully operational.
Picklist: not used, relay x (xx-xx)
If there are several reasons for triggering a relay (e.g. 2 different limit values), this must be set to "Collective
relay" under "Setup -> Outputs -> Relay -> Relay x".
Device fault
The relay switches if the unit detects a system error (e.g. hardware defect).
Picklist: not used, relay x (xx-xx)
If there are several reasons for triggering a relay (e.g. 2 different limit values), this must be set to "Collective
relay" under "Setup -> Outputs -> Relay -> Relay x".
Fig. 24:
Setup - System
Configurable parameters
(factory settings are highlighted in bold)
Commissioning and use during operation
Direct access
10000/000
10005/000
10010/000
10015/000
10020/000
10025/000
10030/000
10035/000
code
41
Advertisement
Table of Contents
