Table of Contents
Advertisement
Commissioning and use during operation
"Inputs" menu
items
Submenu: Universal
View or change settings of the connected measuring points for the selected channel.
inputs, universal input
The unit can be equipped with a maximum of 20 internal signals and a further 20 external signals.
x
Fig. 36:
Signal
Range
Connection
Only for "Resistance
thermometer"
Channel ident.
52
Enter the measured value correction ("offset") for the start and end of the measuring range (not necessary for pulse/
Configure the failsafe mode (e.g. in the event of cable open circuit)
Do set points have to be defined?
Configurable parameters
(factory settings are highlighted in bold)
Setup - Inputs, submenu: Universal inputs, Universal input
Select the type of signal connected (current, voltage, etc.). The channel
is switched off if no signal type is selected (factory default).
Picklist: switched off, current, voltage, resistance therm. RTD,
thermocouple, pulse counter, frequency input, Fieldbus (option),
Modbus Master (Option)
Select the input range or which resistance thermometer/thermocouple
is connected. The terminal assignment is provided in Section 4.
Specify whether RTDs are connected as 2-, 3- or 4-wire systems. Factory
setting: 3-wire
Identifier for the measurement point connected to this input (e.g.
"Pressure", "Temperature", "Heater", ...). 16-character entry.
Factory setting: analog x
Advanced Graphic Data Manager
▾
frequency)
▾
▾
Yes
See "Setup -> Application -> Set points"
->
No
?
End
Direct access
code
20000/000
to
20000/039
20005/000
to
20005/039
20010/000
to
20010/039
20015/000
to
20015/039
Advertisement
Table of Contents
