Table of Contents
Advertisement
Advanced Graphic Data Manager
"Search in trace" menu
items
Search criterion
Date
Only when searching by "Time"
Time
Only when searching by "Time"
Search filter
Only when searching by "Events"
Start search
6.5.6
Extras - Search in trace
Search for events or times in the internal memory.
Fig. 66:
Extras "Search in trace"
You can search for a specific time or event in the memory.
When you are searching by "Time" this point is shown in the graphic.
When you are searching by "Events", the ones found are displayed as a list.
Enter the required date. Default value: today's date
Enter the required time. Default value: current time
For a better overview a search can be conducted looking for specific events (e.g. only setup changes). In the standard all
events are shown.
Picklist: all events, alarm limit violation, on/off events, setup change, power on/off, service, external memory, user
administration, acknowledging messages, miscellaneous
Start search with setup parameters
Search result when "Searching by time":
The time you are searching for appears as a curve on the display shortly after the search is started.
Turn the navigator clockwise or counterclockwise to scroll back and forth between the measured
value curves. You can change the speed with softkey 3 (slow "<" to fast "<<<<"). This function can
also be called up in the instantaneous value display mode during ongoing operation by pressing
softkey 3 "Search". To go back to the instantaneous value display mode, press softkey 1 "Esc".
The gray header indicates that historical values are being displayed (this header is blue
during instantaneous value display).
Commissioning and use during operation
Description
(factory settings are highlighted in bold)
89
Advertisement
Table of Contents
